Search
Search results
-
PCB Editor
... full control over the selection memory feature. Mask Level Controls Click the Mask Level button at the bottom right of ... PCB electrical and routing rule definitions. Design Rules The PCB Editor is a rules-driven environment. As you work in the ...
admin - 04/17/2014 - 11:29
-
Design Rules Reference
Rules are defined and configured in the PCB Rules and Constraints Editor In Altium Designer, design rules are used ... Rules Routing Rules SMT Rules Mask Rules Plane Rules Testpoint Rules Manufacturing ...
admin - 09/13/2017 - 15:32
-
Via
... is to be nominated as a bottom layer test-point. Solder Mask Expansions Expansion value from rules - Enable this option to allow the existing solder mask expansion rule ...
admin - 11/06/2013 - 09:54
-
Pad
... as curved connection lines in the PCB Editor. The Design Rules Checker will not report jumper connections as unrouted nets. ... Test Point Report to generate this report. Paste Mask Expansion The Paste Mask Expansions defines the amount of opening ...
admin - 08/19/2015 - 11:29
-
Pad
... landing area from the center of the pad hole. Paste Mask Expansion Expansion value from rules - Enable this option to allow the existing paste mask expansion rule ...
admin - 11/06/2013 - 09:54
-
Design Rules Enhancements
In Altium Designer, design rules are used to define the requirements of the design. These rules cover ... Normal, Mask, or Dim Use the drop down to select Normal , Mask or Dim ...
admin - 09/13/2017 - 15:32
-
Unary and Binary Rule Types
See Also Design Rules Reference There are two types of design rules - unary and ... two rule scopes.An example of a unary rule is the Solder Mask Expansion rule. This rule applies individually to each pad identified by ...
admin - 08/13/2015 - 06:12
-
PCB
... that is imposed in the editor can be set to Normal , Mask or Dim , where in practice, Mask has the most obvious highlighting ... defined xSignal can then be used to scope relevant design rules such as Length and Matched Length, which will then be obeyed during ...
admin - 01/06/2015 - 09:29
-
Tutorial - Getting Started with PCB Design
... phase is to layout the PCB in accordance with the PCB design rules, the final phase is to generate the fabrication and assembly outputs. ... The amount that the schematic fades is controlled by the Mask Level , click the button down the bottom right of the workspace and slide ...
admin - 08/03/2016 - 04:12
-
Silk To Solder Mask Clearance デザインルール
Language Silk To Solder Mask Clearance Design Rule Related Videos ... To Solder Mask Clearance Rule Related Design Rules Silk To Silk Clearance Minimum Solder Mask Sliver ...
admin - 08/23/2019 - 14:29